两级序批式MBR膜污染特性研究

采用两级SBR与膜法相结合的两级序批式MBR工艺处理生活污水,考察两级序批式运行模式对膜污染特性的影响.对运行111 d后的平板膜污染阻力分布进行了测算,并对两级序批式MBR与连续流单级好氧MBR的平板膜污染速率进行对比试验.结果表明: 两级序批式MBR的平板膜污染阻力以凝胶极化阻力为主,占总阻力的43%,沉积阻力较低,仅占总阻力的10%;与连续流单级好氧MBR相比,两级序批式MBR可以在更高的膜通量下运行,保持更低的膜污染速率,在运行42 d后,过膜流量从100 L/h下降至85 L/h,过膜压差从1.52×10~4 Pa增加至2.22×10~4 Pa;而连续流好氧MBR系统,过膜流量从61 L/h降低至39 L/h,过膜压差却从1.01×10~4 Pa增加至2.63×10~4 Pa.研究表明,两级序批式MBR工艺可以改善膜过滤过程的水力条件,从而有效地减缓浓差极化,降低沉积污染及凝胶层污染,序批式、膜间歇运行与空曝的结合起到了关键性作用.     

SBR降解动力学研究

采用SBR工艺处理有机废水，在已有工艺条件下对生物降解动力学进行了研究，得出生物降解反应为一级反应。研究表明，用Monod公式能较好反映出有机物的降解规律，确定了其动力学参数V_max=14.6306 d^-1，K_s=83.2993 mg/L，得出SBR降解动力学模型为V=14.6306X·S/(83.2993+S)。利用以动力学为基础的动态模拟法优化SBR工艺，实验结果表明该方法合理可行，对SBR的设计与运行有一定的指导作用，可作为SBR反应器扩大实验和设计的依据。     

好氧-缺氧-闲置运行模式处理生活污水

在3个序批式反应器中,利用好氧-缺氧-闲置的运行模式处理实际生活污水,比较了不同曝气时间（2、3和4h）条件下的处理效果,结果表明,在R2（2 h）反应器中成功实现了单级好氧除磷和内聚物驱动的短程硝化反硝化。采用此反应器运行模式,对实际生活污水进行长期处理,反应器的COD、TN和TP的平均去除率分别为85.29%、74.09%和87.97%。本研究表明,在好氧-缺氧-闲置的运行模式下处理生活污水,能成功地实现单级好氧除磷与内聚物驱动的短程硝化反硝化的结合,并且在长期运行的过程中,能稳定地取得较好的脱氮、除磷效率。     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水，考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时，COD去除率约为87%，出水COD在2500mg/L以下，出水挥发性脂肪酸（VFA）浓度为4~6mmol/L，最佳容积负荷为15.0kg/（m3·d）；采用SBR处理UASB出水，当容积负荷为1.5kg/（m3·d）时，出水COD在200mg/L以下，COD去除率在83%以上，ρ（NH₃-N）在5mg/L以下，TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷，加入量为5mL/L，处理后废水TP为4~6mg/L。处理后废水的COD，ρ（NH₃-N），TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

采用两段SBR工艺处理石化废水

采用两段序批式活性污泥反应器（SBR）工艺处理高浓度石化废水，考察了DO、MLSS、反应温度对废水处理效果的影响。实验结果表明，两段SBR系统中有机物降解存在着不同的作用机理，第一段主要以去除易降解有机物为主，第二段主要以去除难降解有机物为主。在进水COD为4000mg／L、SBR1中DO为4～5mg／L、MLSS为5000mg／L，SBR2中DO为2～4mg／L、MLSS为3000mg／L、反应温度约为20℃的条件下，废水COD去除率达90％以上。     

Effect of ozone injection on the long-term performance and microbial community structure of a VOCs biofilter

For biofilters treating waste gases containing volatile organic compounds(VOCs), biomass accumulation is a common problem which will induce bed clogging and significant decrease in VOCs removal efficiency during long-term operation. In this study, ozone injection was developed as a biomass control strategy, and its effects on the biofilter performance and the microbial community structure were investigated in long-term operation. Two biofilters,identified as BF1 and BF2, were operated continuously for 160 days treating gaseous toluene under the same conditions, except that 200 mg/m3 ozone was continuously injected into BF1 during days 45–160. During the operation period, ozone injection did not change the toluene removal efficiency, while the pressure drop of BF1 with ozone injection was significantly lowered compared with BF2. The wet biomass accumulation rate of BF1 was 11 g/m~3/hr, which was only46% of that in BF2. According to the carbon balance result, ozone injection also increased the toluene mineralization rate from 83% to 91%, which could be an important reason for the low biomass accumulation. The PMA-q PCR result indicated that ozone injection increased the microbial viability of the biofilm. The high-throughput sequencing result also revealed that the dominant phyla and genera were not changed significantly by ozone injection, but some ozonetolerant genera such as Rhodanobacter, Dokdonella and Rhodococcus were enhanced by ozone exposure. All the results verified that ozone injection is capable of sustaining the long-term performance of biofilters by lowering the biomass accumulation, increasing the microbial viability and changing the microbial community structure.     

Types of Ectomycorrhiza of Mature Beech and Spruce at Ozone-Fumigated and Control Forest Plots

In the Kranzberg forest near Freising (Germany) a novel “Free-Air Canopy O₃ Exposure” system has been employed for analysing O₃-induced responses from sub-cellular to ecosystem levels that are relevant for carbon balance and CO₂ demand of 60-year-old beech trees. The below-ground ectomycorrhizal community was studied in two-fold ambient O₃ concentrations (five cores per sampling) and in a control plot with an ambient O₃ concentration (four cores per sampling). Five samplings were taken throughout two vegetation seasons (2003 and 2004). Types of ectomycorrhiza were determined by their morphological, anatomical and molecular characteristics and quantified by counting. The total number of mycorrhizal fine roots was higher at the fumigated plot as compared with the control site. The numbers of ectomycorrhizal types at the fumigated and control plots were 28 and 26, respectively. Cenococcum geophilum was present in all soil cores at all sampling times with a significant increase in abundance under ozone-fumigated trees. Other mycorrhizal types present at higher abundance at the fumigated than at the control plot were identified as Russula densiflora, R. fellea, R. illota, Tuber puberulum, Lactarius sp. 2 and Russula sp. 2. Some mycorrhizal types were present exclusively at the fumigated plot (Fagirhiza fusca, F. setifera, Lactarius acris, Piceirhiza nigra and Russula sp. 1). A possible ecological role for the abundant types of ectomycorrhiza and their putative application in bio-indication is discussed.     

序批式动态膜生物反应器处理低碳氮比废水的试验研究

以序批式动态膜反应器为研究对象,对其处理低碳氮比废水的效果进行了试验研究.试验温度为19 ～ 21℃,MLSS为3～5g/L;好氧阶段溶解氧质量浓度为2 ～4 mg/L,厌氧阶段溶解氧质量浓度为0.2～0.5 mg/L;水力停留时间共12 h,其中好氧阶段8h,厌氧阶段4h.结果表明:当进水COD、TN和NH4+-N质量浓度分别为250～300mg/L、103 ～ 156 mg/L和92～140 mg/L时,反应器对上述污染物表现出较高且稳定的去除效率,COD、TN和NH4+-N平均去除率分别达到76.15％、82.16％和90.13％.同时,反应器系统中污泥的比硝化速率与常规处理装置中的活性污泥相比较高,以NH4+-N的降解量计为0.101 d-1,以NO3--N的积累量计为0.091 d-.     

初始pH对厌氧环境下污泥中抗生素抗性基因行为特征的影响

污水处理厂产生大量的剩余污泥中含有丰富的抗性基因,给环境带来了潜在风险。以城市污水处理厂的剩余污泥为研究对象,在不同初始p H(对照组、初始p H=3、5、7、9、11)下观察厌氧条件下,8种抗生素浓度以及四环素类抗性基因(tet A、tet G、tet L、tet M、tet O、tet Q、tet W、tet X)、磺胺类抗性基因(sul I、sul II)和Ⅰ类整合子(int I 1)的行为特征。研究结果显示,初始p H对抗生素的降解影响较小,污泥中总抗生素的平均去除率为42%。对照组及初始p H为3、5、7、9、11下的总四环素类抗性基因分别削减0.65 log、0.96 log、0.75 log、0.62 log、0.86 log和0.98 log。不同四环素类抗性基因表现相似,在初始p H=3和初始p H=11下部分抗性基因削减较多,特别是tet A、tet G、tet L、tet O和tet X。2种磺胺类抗性基因均无削减,浓度平均上升0.18log。相关性分析显示,总抗性基因与TN、NH3-N、TP、SCOD(溶解性COD)均存在显著相关性(P0.05)。上述研究结果为污泥厌氧消化中抗生素抗性基因减量条件提供参考依据。